Photos

AEDC Model Shop upgrades decrease production time, lower cost

Designer Scott Wieland and Machinist Bill Hopkins observe a new electric discharge machining in operation at the Arnold Engineering Development Center Model Shop as it is being used to produce balances used in the center's 16-foot transonic wind tunnel. (Photo by Bob Boswell)

PHOTO BY: Bob Boswell
VIRIN: 091203-O-0000U-615.JPG
FULL SIZE: 1.08 MB
Additional Details

No camera details available.

IMAGE IS PUBLIC DOMAIN

Read More

This photograph is considered public domain and has been cleared for release. If you would like to republish please give the photographer appropriate credit. Further, any commercial or non-commercial use of this photograph or any other DoD image must be made in compliance with guidance found at https://www.dimoc.mil/resources/limitations, which pertains to intellectual property restrictions (e.g., copyright and trademark, including the use of official emblems, insignia, names and slogans), warnings regarding use of images of identifiable personnel, appearance of endorsement, and related matters.

Go to Gallery