Rake fabricated at AEDC Model and Machine shop to be used for flow calibration at NFAC

The rake hardware that will be used this summer in the Phase II Flow Calibration of the 40-by-80 foot test section at the AEDC National Full-Scale Aerodynamics Complex at the Ames Research Facility, California, was fabricated at the AEDC Model and Machine Shop. Fabrication of the flow characterization rake was kept “in house” due to tight tolerance requirements, the ability to have local oversight of the fabrication efforts, and to keep the flexibility to adjust design constraints on the fly, all the while maintaining schedule for a summer 2017 test entry. The rake is designed to support 27 probes distributed in an array so that flow quality measurements can be made across a representative cross section of the wind tunnel test section. The probes will measure flow static and dynamic pressure as well as flow angles and turbulence over the survey area. Additional sensors on the array will measure tunnel total temperature. The goal of the Phase II Flow Calibration is to characterize the 40-by-80 test section flow quality throughout the tunnel operational envelope and report the results. (U.S. Air Force photo/Rick Goodfriend)

PHOTO BY: Rick Goodfriend
VIRIN: 170220-F-RS654-004.JPG
Additional Details

No camera details available.


Read More

This photograph is considered public domain and has been cleared for release. If you would like to republish please give the photographer appropriate credit. Further, any commercial or non-commercial use of this photograph or any other DoD image must be made in compliance with guidance found at, which pertains to intellectual property restrictions (e.g., copyright and trademark, including the use of official emblems, insignia, names and slogans), warnings regarding use of images of identifiable personnel, appearance of endorsement, and related matters.