3D printing successfully used to fabricate discontinued part for lube oil system
In AutoCAD, Paul Kurtz, an intern for the Test Operations and Sustainment Contractor at Arnold Air Force Base, modified the handle design to make it stronger, particularly at the joints. This photo shown highlights the weak points of the original handle. (U.S. Air Force photo)
PHOTO BY:
Unknown
VIRIN:
190904-F-F3405-0004.PNG
FULL SIZE:
0.1 MB
CAMERA
N/A
LENS
N/A
APERTURE
N/A
No camera details available.
IMAGE IS PUBLIC DOMAIN
Read More
This photograph is considered public domain and has been cleared for release.
If you would like to republish please give the photographer appropriate credit.
Further, any commercial or non-commercial use of this photograph or any other
DoD image must be made in compliance with guidance found at
https://www.dimoc.mil/resources/limitations,
which pertains to intellectual property restrictions (e.g., copyright and
trademark, including the use of official emblems, insignia, names and slogans), warnings
regarding use of images of identifiable personnel, appearance of endorsement, and related matters.