Photos

Building upon success, Tunnel 9 team looks to take 3D printing program to next dimension

Pictured is a petal orifice liner created at Arnold Engineering Development Complex Hypervelocity Wind Tunnel 9 in White Oak, Maryland, using additive manufacturing, otherwise known as 3D printing. The liner is integral to high Mach number tunnel runs at Tunnel 9 and can experience temperatures of several thousand degrees. The refractive metal part has an outside diameter of around 3 inches, an inside diameter of around 2 inches and is nominally 3 inches in length. Additive manufacturing machines at Tunnel 9 are also capable of much larger prints, in the ballpark of 18 to 24 inches in any direction. (U.S. Air Force photo)

PHOTO BY: U.S. Air Force photo
VIRIN: 220808-F-F3405-0001.JPG
FULL SIZE: 1.69 MB
Additional Details

CAMERA

NIKON D50

LENS

N/A

APERTURE

56/10

SHUTTERSPEED

10/1250

ISO

N/A

IMAGE IS PUBLIC DOMAIN

Read More

This photograph is considered public domain and has been cleared for release. If you would like to republish please give the photographer appropriate credit. Further, any commercial or non-commercial use of this photograph or any other DoD image must be made in compliance with guidance found at https://www.dimoc.mil/resources/limitations, which pertains to intellectual property restrictions (e.g., copyright and trademark, including the use of official emblems, insignia, names and slogans), warnings regarding use of images of identifiable personnel, appearance of endorsement, and related matters.